Epson Stylus C58 Service Manual page 66

Epson Stylus C58/C59/ME 2/C79/D78/C90/C91/C92/D92/T20/T20E/T23/T26/S20/T10/T11/ME 30/T21/T24/T27/S21
Do not touch or damage the nozzles or the ink supply needles of the
C A U T I O N
Printhead.
9. Remove the screws (x3) that secure the Printhead, and lift up the Printhead
with a longnose pliers.
±
C.B.P 2.5X8 (Torque: 3 1Kgf.cm)
Figure 4-87. Removing Printhead (1)
10. Disconnect the Head FFC (x1) from the connector (x1) on the Printhead, and
remove the Printhead.
Head FFC
Figure 4-88. Removing Printhead (2)
DISASSEMBLY/ASSEMBLY
Printhead
Procedure Specific to Epson Stylus C58/C59/ME 2
When installing the Holder Board Assy, make sure to check if
the assy is properly installed in the right position. The assy is
likely to be installed in the wrong position.
The Ink Position Label is not included in the Cartridge Cover.
When replacing the Cartridge Cover, order the label
separately and attach the Ink Position Label to the place shown
below.
Ink Position Label
Install the label in this position with
Black to the right.
Figure 4-89. Installing Ink Position Label
After removing/replacing the Printhead, perform the adjustment
A D J U S T M E N T
R E Q U I R E D
in the following order. (Refer to Chapter 5 "ADJUSTMENT")
1. "Ink Charge" (only after replacement)
2. "Head ID Input" (only after replacement)
3. "TOP Margin Adjustment"
4. "First Dot Adjustment"
5. "Head Angular Adjustment"
6. "Bi-D Adjustment"
7. "PF Band Adjustment"
Revision E
Cartridge Cover
66
Confidential