Epson Stylus C58 Service Manual page 45

Epson Stylus C58/C59/ME 2/C79/D78/C90/C91/C92/D92/T20/T20E/T23/T26/S20/T10/T11/ME 30/T21/T24/T27/S21
8. Remove the Head FFC (x1) from the connector (x1), and remove the
Printhead.
Head FFC
Figure 4-20. Removing Printhead (2)
When installing the Sub FFC Guide, follow the steps below.
1. Insert the blade between the ribs.
2. Insert the guide pin into the notch.
3. Push down and secure the Sub FFC Guide in place.
Sub FFC Guide
Guide Pin
Notch
Figure 4-21. Installing Sub FFC Guide
DISASSEMBLY/ASSEMBLY
Printhead
Ribs
Blade
Disassembling Printer Mechanism
When installing the Holder Board Assy, make sure to check if
the assy is properly installed in the right position. The assy is
likely to be installed in the wrong position.
There's no need to remove the Cartridge Cover, when replacing
the Print Head of the Epson Stylus C79/D78. But if the
replacement is required for some reasons, refer to
Printhead" (p64) for the replacement procedures.
The Ink Position Label is not included in the Cartridge Cover.
When replacing the Cartridge Cover, order the label separately
and attach the Ink Position Label to the place shown below.
Ink Position Label
Install the label in this position with
Black to the right.
Figure 4-22. Installing Ink Position Label
After removing/replacing the Printhead, perform the adjustment in
A D J U S T M E N T
R E Q U I R E D the following order. (Refer to Chapter 5 "ADJUSTMENT")
1. "Ink Charge" (only after replacement)
2. "Head ID Input" (only after replacement)
3. "TOP Margin Adjustment"
4. "First Dot Adjustment"
5. "Head Angular Adjustment"
6. "Bi-D Adjustment"
7. "PF Band Adjustment"
Revision E
"4.6.1
Cartridge Cover
45
Confidential