Husqvarna HUV 4214 User Manual page 39

815
Figure 17 Engine Oil Drain Plug and Oil Filter Wrench
Engine Oil Filter Change
1. Drain the engine oil. See Engine Oil Draining on page 36.
2. Place the oil drain pan under the engine oil filter (Figure 18).
3. Remove the engine oil filter. Turn it counterclockwise and drain the residual oil in the filter port and filter into
the oil drain pan. See following NOTE.
NOTE: We recommend using an oil filter wrench of the type shown (2) (Figure 17) (Ampro
equivalent). An oil drip guard can be used to prevent excess oil from dripping onto the engine base plate
(Figure 18). Use an empty quart (one liter) container and cut the bottom off at an angle, then slide the open
area of the container up and under the oil filter before removal. Position the port of the plastic container so
oil will be directed into the oil pan. A drip guard can be made by folding a piece of cardboard, thin metal, or
plastic under the oil filter, forming a channel to direct the filter port oil into the drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner's Manual
Engine Oil
® P/N T70413785A255 or
Page 37