Husqvarna Rider Pro 18 AWD Operator's Manual page 64

13. Oil Filter, Change
WARNING!
Engine oil can be very hot if it is
drained directly after stopping
the engine. Allow the engine to
cool somewhat first.
1. Open the engine cover.
2. Remove the oil filter. If necessary, use a filter
remover.
3. Wipe new, clean engine oil onto the seal for the
new filter.
4. Fit the filter by hand with + 3/4 turn.
5. Run the engine warm, then check that there are
no leaks around the oil filter seal.
6. Check the oil level in the engine, top up if
necessary. The oil filter holds 0.2 litres of oil.
IMPORTANT INFORMATION
Used engine or transmission oil is health-
impairing and must not be disposed of in
the ground or in nature.
Replaced filters must be handed in to the
workshop or other allotted place for
disposal.
Avoid skin contact; wash with soap and
water in case of spills.
14. Hydraulic Fluid Filter, Replacing
Pro 18, Pro 18 AWD
1. Remove the oil filter. If necessary, use a filter
remover.
2. Wipe new, clean engine oil onto the seal for the
new filter.
3. Fit the filter by hand so it just touches + 3/4 turn.
4. Remove the transmission cover and fill the
transmission's oil tank, about 0.3 l oil.
See "11-12. Transmission Oil Level". Be
observant when running the engine as described
below and fill so that the tank is not emptied.
5. Run the engine warm, manipulate the servo
steering, and then check that there are no leaks
around the oil filter seal.
6. Check the oil level in the transmission, top up if
necessary. The oil filter holds 0.3 litres of oil.
7. Replace the transmission cover.
62
– English
LUBRICATION
8009-161
8009-507