Checking And Adjusting The Throttle Cable; Checking And Adjusting The Choke Cable; Inspecting The Muffler - Husqvarna Rider Pro 18 AWD Operator's Manual

Checking and Adjusting the Throttle
Cable
Check that the engine responds to throttle
increases and that a good engine speed is attained
at full throttle.
If doubts arise, contact your service representative.
If adjustments are necessary, they can be made as
follows for the lower cable:
1. Loosen the clamping screw for the cable's
outer casing and move the throttle to the full
throttle position.
2. Check that the throttle cable is mounted in the
correct hole in the lower lever, see illustration.
3. Push the throttle cable's outer casing as far to
the left as possible and tighten the clamping
screw.

Checking and Adjusting the Choke Cable

If the engine produces black smoke or is difficult to
start, this can be because the choke cable is
incorrectly adjusted (upper cable).
If doubts arise, contact your service representative.
If adjustments are necessary, they can be made as
follows:
1. Loosen the clamping screw for the cable's
outer casing and move the choke lever to the
full choke position.
2. Check that the choke cable is mounted in the
upper lever, see illustration.
3. Pull the choke cable's outer casing as far to the
right as possible and tighten the clamping
screw.

Inspecting the Muffler

Check regularly that the muffler is complete and
secured correctly.
Temperature variations and vibrations can mean
that the tightening torque for the screws drops. The
screws should be checked when servicing to
guarantee the correct torque. The tightening torque
should be about 10 Nm. Never use a defective
muffler.
WARNING!
The muffler gets very hot in use
and remains so for a short time
afterwards. Contact can result in
burns. Remember the risk of fire.
MAINTENANCE
8009-144
8009-145
8009-683
27
English –