Name And Function Of Each Part - Sanyo VSP-SV2000P Instruction Manual

Name and Function of Each Part

1
Power cord holder
Secure the power cord to the holder using a
plastic tie or similar as shown in the
illustration.
2
Power supply input terminals
(DC 12 V, GND)
3
ALARM IN/OUT terminals
ALARM
1 2
IN
A
ALARM IN terminals (ALARM IN 1 – 4)
These alarm input terminals are for
connecting to the video servers. Connect
an infrared sensor or similar device to the
terminals to use in detecting intruders.
B
ALARM OUT terminal
Connect a buzzer or lamp to this terminal
to notify you when an alarm has been
detected.
C
Ground terminal (COM)
4
RS-232C connector (RS-232C)
Use this connector to connect the video
server to a modem for transmission of data
along telephone lines, or for connecting the
video server to a computer.
Use the communication/terminal select
switch to change the video server operation
between modem and computer operation.
English
1
ALARM
2
GND
12VDC
ALARM
3 4 COM
OUT
3 4
ALARM
RS-232C
1 2 3 4 COM
IN OUT
IN OUT IN
VIDEO 1 VIDEO 2
5
RS-485 connector (RS-485)
Use this connector when connecting the
video server to a device that is equipped with
an SSP (RS-485) communication function.
After making the connection, select the
connected device in the SSP sub-menu of
the main menu so that the device can be
operated by remote control via the network.
6
Communication/terminal select switches
(1) TERMI
When using RS-485, set this switch to
ON for the last device connected.
(2) PC/MODEM
•
PC: This is for service technician use,
and should not be used by the customer.
•
MODEM: This position should be
selected when a modem is connected
using PPP settings.
Note:
•
Make sure that the video server's power is
turned off before setting the function of the
RS-232C connector.
•
Using the RS-232C connector to connect the
video server to a computer is only done for
service purposes. You should not use the
PC/MODEM select switch yourself.
7
Link indicator
This indicator illuminates when the video
server is connected to a network. It flashes
while data transmission is in progress.
– 5 –
5 6 7 8 9
PC
1 2 MODEM
ON
TERMI
COM A B A B RS485 ETHERNET
OUT IN OUT IN
VIDEO 3
F
ALL RESET
OUT
VIDEO 4