Memorising The Remote Control Buttons - Sharp HT-CN300H Operation Manual

Memorising the remote control buttons

HT-CN300H
You can assign only one function to each button. If you assign two functions to the
button, the newer one will be memorised (learn function).
Memorising operations in the Memory 2
buttons for other equipment
The same buttons are used for both Memory 1 and 2 operations. To store signals in
Memory 1 buttons, set the MEMORY 1/2 selector switch to MEMORY 1, and for
Memory 2 buttons, set the switch to MEMORY 2.
1
Set the MEMORY 1/2 selector switch to MEMORY 2.
2
Move the LEARN/TRANSMIT selector switch to LEARN.
The red learn indicator will light up. Though the red and green learn indicators
light up alternately after approx. 15 seconds, you can go on to the next step.
Lights up
3
Press down the desired button on the remote control for 2 seconds
or more.
The green learn indicator will flash (the red indicator remains lit).
20
4
Within 10 seconds, press down for more than 2 seconds the de-
sired button on the remote control supplied with other equipment
to send the signal to the
When the signal is sent to the remote control of the unit, the green indicator will
go off. When memorisation is completed, it will light up.
If the signal is not memorised correctly, the
red learn indicator will flash. Perform the op-
Alternately light up
erations from step 3 again.
5
Repeat steps 3 and 4 to memorise other buttons.
6
After memorisation is completed, move the LEARN/TRANSMIT se-
lector switch to TRANSMIT.
You can use the remote control.
Lit Flashes
Notes:
You cannot store all the button operations by pressing only one button on the
remote control of other equipment. Memorise them one by one.
After storing operation is completed, check that other equipment works correctly
with the remote control.
Some functions cannot be memorised depending on other equipment.
marking.
Angle and distance
5 cm - 10 cm (2" - 4")
10˚
Lit Goes off
mark
Flashes
02/6/17 HT-CN300H_(E)3.fm
Lit Lights up