Preparing The Remote Control - Sharp HT-CN300H Operation Manual

Preparing the remote control

HT-CN300H
Battery installation
You can operate the remote control with batteries in areas where the AC power lead
cannot reach.
Use 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).
Batteries are not included.
1
Turn the remote control over and place it on a soft cloth.
2
Open the battery cover.
3 Insert the batteries according to the direction indicated in the bat-
tery compartment.
When inserting or removing the batteries, push them towards the
nals.
4 Close the cover.
Precautions for battery use:
Replace all old batteries with new ones at the same time.
Do not mix old and new batteries.
Remove the batteries if the unit is not to be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:
Replace the batteries if the operating distance is reduced or if the operation
becomes erratic.
Periodically clean the transmitter on the remote control and the remote control
sensor with a soft cloth.
Keep the remote control away from moisture, heat, shock, and vibrations.
16
Test of the remote control
Point the remote control directly at the remote sensor.
The remote control can be used within the range shown below:
Press the ON/ (STAND-BY) button. Does the power turn on? Now, you can enjoy
your system.
When the signal is received, the remote control indicator will flash. Whilst in the
dimmer mode (page 23), it will not flash or light.
Remote sensor
battery termi-
15
15
Note:
Exposing the remote sensor to strong light may interfere with operation. Change the
lighting or the direction of the remote control sensor.
How to open the remote control cover
To access the Memory 1/2 buttons, open the remote control cover.
Note:
You can control the DVD, VCR, etc. with this remote control (see page 19).
02/6/17
Remote control
0.2 m - 6 m
indicator
(8" - 20')
HT-CN300H_(E)3.fm
20
20