Sharp AM-900 Service Manual page 30

AM-900U
3.6.3 Bypass temp.
This mode is used to set the temperature of fixing when printing from
the bypass tray.
BYPASS TEMP.
[ENTER]Key
ON temp.=200 deg
[>]Key
OFF temp.=200 deg
[>]Key
FEED temp.=200 deg
[>]Key
TIME=10(s)
[>]Key
1. ON TEMP.
The temperature to start turning on the heater.
• Default value: 200
• Range: MIN: 170, MAX: 233
• Unit: Centigrade
2. OFF TEMP.
The temperature to start turning off the heater.
• Default value: 200
• Range: MIN: 170, MAX: 233
• Unit: Centigrade
3. FEED TEMP.
The temperature to start feeding the paper.
• Default value: 200
• Range: MIN: 170, MAX: 233
• Unit: Centigrade
4. TIME
Warming up time after reaching the temperature that the printing
can be done.
• Default value: 10
• Range: MIN: 10, MAX: 63
• Unit: Second
3.6.4 Flicker adjust
This mode is specified the number of table for the countermeasures of
"FLICKER".
FLICKER ADJUST
• Default value: 06
• Input Range: MIN: 00, MAX: 63
• Unit: -
3.6.5 Parameter list
Printing the parameter for fixing.
PARAMETER LIST
[E NT ER]K ey
Input temperature using the numeric keys
Input temperature using the numeric keys
Input temperature using the numeric keys
Input temperature using the numeric keys
[E NT ER]K ey
FLICKER NO.=06
PRINTING
3.7. Test mode
This mode is used for printer aging on the two modes.
TEST MODE
[ENTER]Key
1: MOTOR AGING
[>]Key
[>]Key
3.7.1 Motor aging
1. The motor aging starts with heater on or with heater off.
1: MOTOR AGING
[ENTER]Key
HT 1: ON 2: OFF
2. To exit the aging, press [STOP] key.
3.7.2 Charger adjust
This mode is used to check the high-pressure control.
1. Operation
1. Press the [ENTER] key to operate the mode.
2. Press the [STOP] key to exit this mode.
3.7.3 Paper feed
This mode is used to check Mechanical Controller in the High speed
mode.
Note: This mode is not used actual printing.
1. Operation
1. Press the [ENTER] key to operate the mode.
2. Press the [STOP] key to exit this mode.
2 – 14
2: CHARGER ADJUST 3: PAPER FEED
[>]Key
[>]Key
5: PRINT SIZE 4: COM TEST
[>]Key
MM_AGING: HT_ON
[1]Key
MM_AGING: HT_OFF
[2]Key
2: CHARGER ADJUST
[ENTER]Key
NOW ADJUSTING
3: PAPER FEED
[ENTER]Key
NOW AGING