Changing The Darkness; Proof Copying - Samsung CLX-9252 9352 Series User Manual

• The hole punch function is available only when the punch kit is
installed in the optional standard or booklet finisher.
• Numbers of punched holes are depending on the punch kit.
You can purchase the 2/3 hole punch kit or 2/4 hole punch kit.
• When you use the punch feature, only the finishing tray is
available for printouts.
• When you have set the the Staple options before setting the
Punch options, some options are not available depending on
the number of staples, staple position and the direction of
paper feeding in the trays.
- Off: Disables this feature.
- 2 Holes: Two holes are punched in the left, right, or top. When the
loaded paper is short edge feeding, you can choose Left or Right;
while the loaded paper is long edge feeding, you can choose only
Top.
- 3 Holes: Three holes are punched in the left, right, or top. When the
loaded paper is short edge feeding, you can choose Left or Right,
while the loaded paper is long edge feeding, you can choose only
Top.

Changing the darkness

Press the Basic tab. You can adjust the degree of darkness using the
left/right arrows. This feature allows dark images to be printed into lighter
images, or light images into darker images.
Refer to the sample images below. Depending on the circumstances and
quality of originals, the printout's quality could be different from the sample
image's.
Light Moderatel
y light
Original Moderatel Dark
y dark

Proof copying

This mode is useful when you print more than one copy. You can print one
copy first to check the quality, then print the rest of copies later.
1. Press Copy from the display screen.
2. Place the originals face up in the DADF or place a single original face
down on the scanner glass and close the DADF (see "Loading originals"
on page 35).
3. Adjust the settings for each copy such as Paper Supply,
Reduce/Enlarge, Duplex and more in the Basic tab (see "Changing the
settings for each copy" on page 54).
4. Enter the number of copies using the numeric keypad.
5. Press Proof Copy.
6. Set the copy features in the Advanced or Image tabs, if necessary (see
"Using special copy features" on page 61).
7. Press Start on the control panel to begin copying.
8. Check the quality of the printout.
9. When the proof copy confirmation window appears, if you like the
printout quality, press Continue. The rest of the copies will be printed
out.
If you press Cancel, the rest of the copies will be cancelled.
Copying_ 60