Setting Up The System - Kenwood VR-605 Instruction Manual

Setting up the system
Make connections as shown in the following pages.
When connecting the related system components, be
sure to refer to the instruction manuals supplied with
the components you are connecting.
Do not connect the power cord to a wall outlet until all
connections are completed.
Notes
1. Be sure to Insert all connection cords securely. If their connectrons are
imperfect, the sound may not be produced or there wrll be noise
interference.
2. Be sure to remove the power cord from the AC outlet before plugging
or unplugging any connectron cords Pluggrng/unplugging connection
cords without disconnectrng the power cord can cause malfunctrons
and may damage the unrt.
3.Do not connect power cords from components whose power
consumption is larger than what IS indrcated on the AC outlet at the
rear of this unit.
Audio connections are made usrng RCA pin cords. These cables transfer
stereo audro srgnal in an "analog" form. This means the audio signal
corresponds to the actual audro of two channels. These cables usually
have 2 plugs each end, one red for the right channel and one white for
the left channel. These cables are usually packed together wrth the
source unit, or are available at your local electronics retarler.
though all connectrons have been made properly, reset the
microcomputer referring to "In case of difficulty".
Input mode settings
CD/DVD, VIDEO2 and DVD or DVD/GCH (VR-615/KRF-V5060D
only) Inputs each Include jacks for drgrtal audio Input and analog audro
Input.
You must select beforehand which type of Input IS to be used for each
connected component.
To usethe analog audro Input for playback Instead (If, for example, you
have connected a VCR to the VIDEO2 Input), you must set the input
mode for the corresponding Input to the analog mode.
After completrng connectrons and turnrng on the recerver, follow the
steps below
INPUT SELECTOR
INPUT MODE
0 Use the INPUT SELECTOR knob to select CD/DVD, VIDEOS,
DVD or DVDIGCH (VR-615/KRF-V5060D only).
0 Press the INPUT MODE key.
Each press switches the setting as follows:
In DTS play mode
0 F-AUTO (digrtal Input. analog Input)
c @ D-MANUAL fdrgltal input)
In CDIDVD, VIDEOZ, DVD or DVDIGCH (VR-615/KRF-V5060D
only) play mode
C
0 F-AUTO (digital Input, analog Input)
0 D-MANUAL (drgrtal Input)
3 6CH INPT (DVD/GCH Input)
'4 ANALOG (analog input)
Digital input:
Select this settrng to play dlgrtal srgnals from a DVD. CD, or LD
player.
Analog input:
Select this setting to play analog srgnals from a cassette deck, VCR,
or record player.
Auto detect:
In "F-AUTO" (full auto) mode (AUTO DETECT and DIGITAL
Indicators light up), the recerver detects the digital or analog input
srgnals automatrcally. Prronty IS given to drgrtal srgnal during input
mode selection. The recerver wrll select the Input modeand listening
mode automatrcally durrng playback to match the type of input
srgnal (Dolby Drgrtal, PCM, DTS) and the speaker setting. The Initial
factory setting is full auto.
To keep the receiver set to the currently selected lrstenrng mode,
use the INPUTMODE key to select "D-MANUAL" (drgrtal manual).
However, even when this setting is selected, there may be cases
rn whrch the lrstening mode IS selected automatically to match a
Dolby Drgital source signal depending on the combination of lrstenrng
mode and source drgital
If the INPUT MODE key is pressed qurckly, sound may not be
produced. Press the INPUT MODE key again
8
EN