Setting Up The System - Kenwood VR-716 Instruction Manual

Setting up the system

M ake connections as show n in the follow ing pages.
When connecting the related system components, be
sure to refer to the instruction manuals supplied w ith
the components you are connecting.
Do not connect the pow er cord to a w all outlet until all
connections are completed.
Notes
1. Be sure to insert all connection cords securely. If their connections are
imperfect, the sound may not be produced or there w ill be noise
interference.
2. Be sure to remove the pow er cord from the AC outlet before plugging
or unplugging any connection cords. Plugging/unplugging connection
cords w ithout disconnecting the pow er cord can cause malfunctions
and may damage the unit.
3. Do not connect pow er cords from components w hose pow er
consumption is larger than w hat is indicated on the AC outlet at the
rear of this unit.
Analog connections
Audio connections are made using RCA pin cords. These cables transfer
stereo audio signal in an " analog" form. This means the audio signal
corresponds to the actual audio of tw o channels. These cables usually
have 2 plugs at each end, red for the right channel and w hite for the left
channel. These cables are usually packed together w ith the source unit,
or are available at your local electronics retailer.
M icrocomputer malfunction
If operation is not possible or an erroneous display appears, even
though all connections have been made properly, reset the
microcomputer by referring to " In case of difficulty" .
8 EN
Input mode settings
CD / DVD, VIDEO 2 and DVD/ 6CH inputs each include jacks for digital
audio input and analog audio input.
After completing connections and turning on the receiver, follow the
steps below .
LISTEN MODE
INPUT MODE
1 Use the INPUT SELECTOR knob to select CD/ DVD, VIDEO 2,
DVD/ 6CH.
2 Press the INPUT M ODE key.
Each press sw itches the setting as follow s:
In DTS play mode
1 F-AUTO (digital input, analog input)
2 D-M ANUAL (digital input)
In CD/ DVD, VIDEO 2, DVD/ 6CH play mode
1 F-AUTO (digital input, analog input)
2 D-M ANUAL (digital input)
3 6CH INPT (DVD/6CH input)
4 ANALOG (analog input)
‡
Digital input:
Select this setting to play digital signals from a DVD, CD, or LD
player.
Analog input:
Select this setting to play analog signals from a cassette deck, VCR,
or record player.
Auto detect:
In " F-AUTO " (full auto) mode ( AUTO DETECT and DIGITAL
indicators light up), the receiver detects the digital or analog input
signals automatically. Priority is given to digital signal during input
mode selection. The receiver w ill select the input mode and listening
mode automatically during playback to match the type of input
signal (Dolby Digital, PCM , DTS ) and the speaker setting. The initial
factory setting is full auto.
To keep the receiver set to the currently selected listening mode,
use the INPUT M ODE key to select " D-M ANUAL " (digital manual).
How ever, even w hen this setting is selected, there may be cases
in w hich the listening mode is selected automatically to match a
Dolby Digital source signal depending on the combination of listening
mode and source digital.
In D-M ANUAL mode, if the audio reproduction stops in the middle
due to change in the input signals, etc, press the LISTEN M ODE
key. If the INPUT M ODE key is pressed quickly, sound may not be
produced. Press the INPUT M ODE key again.
INPUT SELECTOR