Norma/Playback - Kenwood VR-605 Instruction Manual

Normal playback
Some preparatory steps are needed before starting playback.
POWER OhSTANDBY
(3
;;F&E" ON/STANDBY 0 (K~F-V~'J60DI~~~~~~;
(Vq-605/615) I
O&l/OFF 1
(KRFW;;;
INPUT MODE
V5560D)
Turning on the receiver
0 Turn on the power to the related components.
0 Turn on the power to this receiver by pressing POWER ON/
STANDBY 0 (for VR-605/615) or POWER ON/OFF and ON/
STANDBY 0 (for KRF-V5060DIV4060D/V556OD~ key.
Selecting the input mode
If you have selected a component connected to the CDIDVD, VIDEOZ,
DVD 01 DVD/GCH (VR-615/KRF-V5060D only) jacks. make sure that
the Input mode setting IS correct for the type of audio signal to be used
.~
-I&
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MDflAPE lacks The lnitlal factory setting IS "TAPE". To change the
source to "MD", follow the steps below
0 Use the INPUT SELECTOR knob to select "TAPE".
0 Hold down the AUTO key for more than 2 seconds.
*The source indication changes to "MD".
*To return to the orlglnal Indlcatlon, repeat procedure 0
Setting the speaker status
The speaker Indicator lights up.
VOLUME CONTROL
INPUT SELECTOR
l I--
VOLUME
a Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
The Input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
VR-605/615/KRF-V5060D/V4060D/V5560D
I
'\T, "AUX"
Q' "TUNER"
i:- " CDI
DVD"
4 "TAPE" or "MD"
8s "VIDEOl"
6 "VIDEOZ"
'i "DVD" or "DVD/GCH" (for VR-615/KRF-V5060D only)
KRF-V5060D (for the U.K. and Europe only)
'1 "PHONO"
<i "TUNER"
,3 "CDIDVD"
T "TAPE" or "MD"
5,,
"VIDEO1 "
6' "VIDE02"
i "DVDIGCH"
q
Stari playback from the selected source.
q
Use the VOLUME CONTROL knob or VOLUME keys to adjust
the volume.
Press the SPEAKER key to switch the speaker ON or OFF.
lgEN