Setting The Clock - Sharp SD-SH111 Operation Manual

Setting the clock

By setting the unit on time, you can use it not only as a clock but also for timer play-
back.
[Back]
In this example, the clock is set for 9:30 AM.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TIMER button.
3
Within 10 seconds, press the or
and then press the ENT button.
4
Press the
hour and then press the ENT button.
5
Press the
minutes and then press the ENT but-
ton.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the DISPLAY button on the remote control.
The time display will appear for about 5 seconds.
[When the power is on]
Press the TIMER button.
Within 10 seconds, press the
The time display will appear for about 10 seconds.
To readjust the clock:
Perform "Setting the clock" from the beginning.
In step 2, "TIMER STANDBY" appears. If the clock is cleared, "SLEEP" appears.
button to select "ADJUST",
In step 3, press the
ton.
Caution:
Unplugging the unit or power failure will clear the clock setting.
Perform "Setting the clock" from the beginning.
"AM 12:00" is 12 o'clock midnight.
or button to adjust the
"PM 12:00" is 12 o'clock noon.
Press the or button once to advance the time by 1 hour. Hold it down to
advance continuously.
The 12-hour display will appear.
"AM" will change to "PM" automatically.
or button to adjust the
Press the or button once to advance the time by 1 minute. Hold it down
to advance continuously.
The hour will not advance even if minutes advance from "59" to "00".
The clock starts from "0" second. (Seconds are not displayed.)
or button to select "CLOCK".
or button to select "CLOCK", and the press the ENT but-
02/11/20 SD-SH111(U)E3.fm
SD-SH111
ENGLISH
7
E-26