Table of Contents
Advertisement
INSTALLATION OF THE DMP
The box for your DMP should contain the
following items:
• the DMP
• a Remote control with 2 AAA batteries
• an Audio/Video cable(fully featured 1,0 metre)
• an AC power cord
• an Owner's Manual
• a Software License agreement
About the Audio/Video sockets
• The rear panel of the DMP is equipped with 4 Phono sockets
(see figure on page 6).
• Audio/Video cables are also necessary to get stereo sound
from a stereo TV and video recorder.
Preparing the Remote Control
• Remove the cover on the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA (1,5 V) batteries, as shown in the diagram,
taking care to observe the + and - markings indicated inside.
• Replace the cover.
Connecting the DMP to the Dish
If you need to fit the F-connectors onto the cable
• Prepare each end of the cable as shown in the diagram. You
will need to fold back the outer braid (as shown).
• Slide the F-connector onto the cable, then turn it clockwise
until it grips the braid.
• Ensure that 3 mm of the core is protruding from the end of the
connector.
Installing the Satellite Dish
• See the "Fitting instructions for satellite dish" on how to in-
stall the dish.
• Connect the coaxial cable, with F-connectors fitted, from the
LNB on the satellite dish to the socket marked "ANTENNA"
on the rear panel of the DMP.
GB 8
AC power
Audio/Video
cord
cable
License
Owner's manual
agrement
15 mm
8 mm
F-connector
3 mm
Advertisement
Table of Contents
