Tuning Procedure When Rf Connections Are Used - Nokia 8830 S Owner's Manual

Tuning Procedure when RF Connections are Used

This procedure is necessary only if your DMP is connected
to the TV with an RF lead.
To tune your TV to the RF signal you might also need your TV
manual in addition to this manual. The steps below explain what
to do if you have been unable to use Audio/Video leads in your
connection.
• Plug in your DMP.
Tuning your TV to the DMP
• Select a channel number on the TV that is not currently used
for other TV channels.
• Follow the instructions in your TV manual to tune the TV chan-
nel selector to VHF channel 3 (this is the DMP's factory pre-
set VHF channel). If you are already using this channel, select
channel 4.
• If you need to change VHF channel you do as follows:
First you change on the DMP. Use the
front panel of the DMP, or on the remote. You will see the VHF
channel number displayed on the front panel of the DMP. Then
you tune the TV channel selector to the same VHF channel.
• When you have correctly changed the VHF channel number
you will see the " Welcome " menu on the TV screen.
If there is interference from other channels you will have to
change the chosen VHF channel.
• Follow the instructions in your TV manual to store this VHF chan-
nel as the channel used by your DMP. You will have to select it
when you want to watch digital TV/Radio channels.
• Once the welcome message is visible, press the OK button
on the DMPs remote control to start the installation procedure.
If for some reason you have to change the RF channel later,
you can do this by using TV settings menu further on in this
manual.
If you have a VCR connected it must be tuned to a different
VHF channel (between 3 to 4) than the DMP.
You may now proceed to "First Time Installation."
or buttons on the
GB 11