Using The Remote Control Unit - Sanyo DMP-P7 Instruction Manual

Install/Replace the Remote Control Battery
The remote control battery is already installed at the factory. When the remote control stops operating, replace
the battery with a new one.
1. The battery door is located on the back end of the unit.
Squeeze notched tab A while pulling battery door latch B to
2.
release the battery door latch and take out the battery holder.
3. Insert a "CR2025" 3-volt lithium battery. Make sure the polarity
(the + and - side of the battery) is correct.
Replace the battery holder back in the remote control.
4.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
The Remote Control controls basic functions on the clock radio. For best results, aim remote control towards the
grill by the lower right corner of the display.
23. POWER ON/OFF Button
24. MUTE Button
25. PRESET Button
26. SLEEP
27. PROG Button
28. BAND/RADIO Button
29. ST/MONO Button
30. iPod PLAY/PAUSE Button
31. Button
32. Button
33. VOLUME - Button
34. VOLUME + Button

Using The Remote Control Unit

23
25
27
BAND/
RADIO
29
ST/
MONO
31
33
Turns clock radio ON or OFF or reset alarm when alarm is sounding
Mutes the sound
Selects preset radio stations
Selects sleep function
Stores radio program
This button switches between AM and FM radio bands.
Switches the receiver between FM stereo and mono modes. Mono
reduces the noise heard when listening to weak FM stations.
iPod and plays track. In play mode, press to pause.
Skip to previous or next track when iPod is playing, or HOLD to scan
current playing track. In radio mode, press to tune stations. HOLD to
scan radio stations.
Lowers volume level
Raises volume level
24
26
28
30
32
34
6
A
B
Battery
door latch