Remote Control Battery - Sanyo DMP-P8 Instruction Manual

Remote Control Battery

The remote control requires one"CR2025 type"3-volt lithium battery
(included). To extend the life of the original battery we have inserted
a small clear plastic spacer tab between the lithium battery and the
battery terminal. You must remove this battery spacer tab before you
use the remote control. To remove the tab, pull it in the direction of
the arrow in the illustration as shown:
When the operation of the remote control becomes unsatisfactory,
replace the original battery with a new 3-volt lithium battery.
1. Slide out the battery holder from the remote control case. (Push tab
"A" towards the middle first, see diagram).
2. Place one 3V CR2025 battery into the battery holder, observing the
positive (+) direction. If the battery is placed incorrectly the remote
control will not work.
CAUTION: Danger of explosion if the battery is replaced incorrectly.
Replace only with the same or equivalent type.
3. Insert the battery holder into the battery compartment.
Note: Please remove all of the batteries to prevent damage or injury
from possible battery leakage if the unit is not to be used for a long
period of time.. Use only the specified size and type of battery.
- 8 -