Af Spotbeam - Samsung SEF-36PZF User Manual

AF SPOTBEAM

SEF-36PZF features a built-in red spot beam
projector to assist the autofocus system in dim light
and low-contrast conditions. When using the flash
with autofocus camera in dark conditions, the spot
beam will be projected automatically depending on
the ambient lighting conditions. With the sync mode
switch set to [S.B.], the SEF-36PZF can be used
exclusively as a focusing aid in dim light.
Using the SEF-36PZF Spot beam Exclusively as a Focusing Aid
1. Set the main switch to the [ON] position.
2. Set the flash mode switch to the [SB] position.
3. Set the camera to the autofocus mode.
4. Press the shutter release button halfway down.
The AF spot beam will automatically be projected
lights up indicating that you are ready to shoot.
《46》
• The AF spot beam does not work in bright light
conditions.
• If the In-focus indication does not light up in
several seconds, it means that the subject is
hard to autofocus. In this case, use the manual
focus mode to focus on the subject.
• To change the composition, raise your finger
off the shutter release button and press it
halfway down again to recompose the picture.
• When using the SEF-36PZF's built-in AF spot
beam, the AF spot beam built into the camera
will not operate.
• The AF spot beam on the flash unit works
accurately only when mounted onto the
camera's hot shoe. The AF spot beam does
not operate accurately when the bounce flash
is used.
• The flash does not fire when using the SEF-
36PZF spot beam exclusively as a focusing
aid.