Sharp KB-4425LW Installation Manual page 3

• Read a llofthe Installation Manual before i nstalling the range.
° Remove allpacking material from the oven a nd drawer before
connecting the electrical supply t othe range.
• Observe allgoverning codes and ordinances.
• Besure toleave t hese i nstructions withtheconsumer.
Keep t his manual withyour O peration Manual forfutm'e r eference.
° Aswhen u sing anyrange g enerating heat, there arecertain
safety p recautions youshould f ollow. These a relisted inthe
Operation Manual. Read a lland follow carefully.
° Besure yourrange i sinstalled a nd grounded properly bya
qualified installer orservice technician.
1 Remove all packing
materials from inside
the Microwave Drawer
andtheoven cavity.
DONOTREMOVE
THEWAVEGUIDE
COVER, w hichis
located onthe top
of the Microwave
Drawer.
2 Remove the feature
sticker, if there is one.
Check the drawer for
any damage, such as
misaligned or bent
Sealing Surface __
Waveguide
Cover
ig Surface
Microwave
Drawer Cavity
drawer, damaged drawer seals and sealing surfaces, broken
or loose drawer guides and dents inside the drawer or on the
front side of the drawer. If there is any damage, do not operate
the Microwave Drawer and contact your dealer or a SHARP
AUTHORIZED SERVICER.
_If the information in this manual is not followed
exactly, a fire or electrical shock may result causing property damage,
personal injury or death.
ALL RANGES CAN TIP
INJURY TO PERSONS COULD RESULT
iNSTALL ANTI-TIP BRACKET PACKED
WiTH RANGE
SEE ANTI-TIP BRACKET TEMPLATE
FOR iNSTALLATiON INSTRUCTIONS
iNSTALLATiON MANUAL
_To reduce the risk of tipping the range, it must
be secured by properly installed Anti-Tip bracket packed with
the range.
e
®
This range must be electrically grounded in accordance with
local codes, or in their absence, with the National Electrical
Code ANSI/NFPA No. 70--latest edition in United States.
The installation of ranges designed for manufactured (mobile)
home installation must conform with Manufactured Home
Construction and Safety Standard, title 24CFR, part 3280
[Formerly the Federal Standard for Mobile Home Construction
and Safety, title 24, HUD (part 280)] or when such standard
is not applicable, the Standard for Manufactured Home
Installation 1982 (Manufactured Home Sites, Communities
and Setups), ANSI Z225. 1/NFPA 501A- latest edition, or with
local codes in United States.
Make sure the wall coverings and the cabinets around the range
can withstand the heat generated by the range.
Before installing the range in an area covered with
linoleum or any other synthetic floor covering, make sure
the floor covering can withstand heat at least 90°F (32.2°C)
above room temperature without shrinking, warping or
discoloring. Do not install the range over carpeting unless
you place an insulating pad or sheet of t/4-inch (0.64cm) thick
plywood between the range and carpeting.
_ Never leave children alone or unattended in the
area where an a range is in use. As children grow, teach them the
proper, safe use of all appliances.
_ Stepping, leaning or sitting on the door or drawer
of this range can result in serious injuries and can also cause damage
to the range.
° Do not store items of interest to children in the cabinets
above the range. Children could be seriously burned climbing
on the range to reach items.
° To eliminate the need to reach over the cooktop, cabinet storage
space above the cooktop should be avoided.
• Do not use the oven as a storage space. This creates a
potentially hazardous situation.
• Never use the range for warming or beating the room.
• Do not store or use gasoline or other flammable
vapors and
liquids near this or any other range. Explosions or fires could
result.
Reset all controls to the "off" position after using a
programmable timing operation.
WHEN USING THE SELF-CLEAN FEATURE:
• Remove broiler pan, oven racks, food and other utensils
before self-cleaning the oven. Wipe up excess spillage. Follow
the precleaning instructions in the Operation Manual.