Table Of Contents; Design Information; Product Clearances - GE ZVC36LSS Installation Instructions Manual

Design Information
CONTENTS
Design Information
Product Clearances .......................................................................... 4
Product Dimensions .................................................................... 5-7
Advance Planning
Advance Planning ............................................................................ 8
Remote Mounting of the Control (Wired) .............................. 8
Power Supplg ...................................................................................... 8
Duct Fittings ...................................................................................... 9
Installation Preparation
Tools and Materials Required .................................................... !0
Remove the Packaging ................................................................ !0
Parts Provided ..................................................................................
11
Ductwork, Wiring Locations ...................................................... 12
Construct Ceiling Support .......................................................... 13
Remote Mounting of the Control (Wired) ...................... !4-15
Installation Instructions
Step 1, Install Hood Liner ............................................................ 16
Step 2, Connect Electrical ............................................................ 17
Step 3, Install Insert Sleeve ........................................................ !8
Step 4, Install Damper Plate ...................................................... 19
Step 5, Install Blower Motor ........................................................ 20
Step 6, Connect Wiring Harness .............................................. 20
Step 7, Install Filters ...................................................................... 21
Step 8, Finalize Installation ........................................................ 21
PRODUCT CLEARANCES
The vent hood and liner assemblg must be installed
50" minimum and 36" maximum above the cooking
surface.
NOTE: Installation height should be measured
from the cooking surface to the bottom edge
of the metal hood liner or cabinet surface.
NOTE: UL requires ang combustible surface to be
a minimum of 50" above the cooking surface.
• This hood must be vented to the outdoors.
• This hood mag be mounted onto a wall or installed
over an island.
• This hood can be installed over ang Monogram
electric!gas cooktop or Monogram Professional
cooktop or range of equivalent width.