Remote Mounting Of The Control (Wired) - GE ZVC36LSS Installation Instructions Manual

Installation
Preparation
REMOTE MOUNTING OF THE CONTROL
(WIRED}
-- IL WARNING: Disconnect electrical
power from unit before beginning remote control
installation. Failure to do so could result in personal
injurg or damage to the electrical controls.
AVERTISSEMENT
: llfaut
d_brancher I'alimentation 61ectrique de I'appareil
avant de commencer I'installation de la commande
distance. II faut suivre cette directive pour @viter
des blessures ou endommager les commandes
61ectriques.
REMOTE LOCATION FOR CONTROL
The control can be removed from the hood and
installed in a backsplash or countertop.
• A cover plate is provided to cover the opening in
the hood when the control is removed.
• A 30-ft. length of 4-wire cord is supplied to
accommodate most installations. Because onlg
30-ft. of cord is provided, careful consideration
must be given to the location of the remotelg
mounted control.
NOTE: Not for telecommunication (telephone}
network.
• The cord must be routed through the holes in the
insert sleeve, and the rubber grommets put into
place around the cord.
NOTE: On the ZVC30 and ZVC36 models, the cord
needs to be routed through the holes in the insert
sleeve before the damper plate is installed.
• Route the cord through the conduit to reach the
installation location of the control.
1-11116"
3-11/16"
P
Control cutout
14