GE ZVC36LSS Installation Instructions Manual page 15

Installation
Preparation
REMOTE MOUNTING OF THE CONTROL
(WIRED) {CONT.)
COUNTERTOP
WALL MOUNT
Control
• , _"-"r"--..Co nne cto r
4-wire cordi-._" :
_ Mounting plate
Screws 4,-_ _--
Mounting bracket _ Apply silicone around
_cutout opening
I. Cut out opening in the countertop. Cutout
dimensions ore i-ii/16" x 3-ii/16".
2. Loosen the/4 thumbscrews ond remove the control
from the insert sleeve. Reploce the control with the
blanking plate provided.
3. Attoch the mounting plote to the bock of the
control with the 2 mounting plote screws.
4. Pull the a-wire cord through the opening in the
countertop, ond through the bock of the mounting
brocket.
NOTES: Use provided cable or cable designated bg
the National Electrical Code, NFPA/ANSI 70, or local
codes. Not for telecommunication (telephone}
network.
5. Connect the 4-wire cord to the jack of the
connector on the control.
6. Press the control firmlg into the mounting brocket
so that the clips engoge.
7. Applg silicone oround the cutout opening.
8. Insert the control into the cutout opening.
Wall
bracket
Screws,
Mounting Control
bracket
¼ Jack
__ord
plate
I. Cut out opening into the woll surface. Cutout
dimensions are 1-11/16" x 3-11/16".
2. Loosen the/4 thumbscrews ond remove the
control from the insert sleeve. Replace the
control with the blonking plote provided.
3. Attach the mounting plote to the bock of the
control with the 2 mounting plote screws.
4. Pull the a-wire cord through the opening in
the wall, the woll brocket ond the back of the
mounting brocket.
NOTE: Use provided cable or cable designated bg
the National Electrical Code, NFPA/ANSI 70, or local
codes. Not for telecommunication (telephone}
network.
S. Connect the mounting brocket to the woll bracket
using the two wall brocket screws. Onlg start the
first 1-2 threads of the screws into the woll, os
gou wont to leove o gop between the two
brockets to occount for the woll thickness.
6. Raise the tabs on the mounting Tabs
brocket so the brocket will fit ,F_-------"_
through the woll opening.
7. Angle the mounting ond woll
brackets ond slide them through the woll cutout.
NOTE: Attach a string to the brackets, so gou can
retrieve them from behind the wall if dropped.
8. Flotten tobs on mounting bracket so theg ore
flush with the wall surfoce, ond tighten the woll
brocket screws to pull the woll brocket flonges
flush with the bockside surfoce of the woll.
9. Connect the a-wire cord to thejock of the
connector on the control.
I0. Press the control firmlg into the mounting
brocket so thot the clips engoge.
15