Multiplexer Setting; Alarm Display Setting - Mitsubishi Electric DX-TL4509E Quick Start Manual

Multiplexer Setting

The multiplexer function of this unit can display the connected cameras on 2 Monitor outputs.
Monitor A and Monitor B using split screens.
It is also possible to change the position of the camera number to be displayed in the SPLIT modes.
To change the settings enter the System Menu:
Press the SET UP Button on the front of the DVR
From the User Menu screen (000 000 000), press the D
NEXT button to display the Setup Menu
(200 000 000) Press 4

Alarm Display Setting

This item is used to display the picture input with
alarm signal in the single screen display or split
screen display which has been pre-set.
When another alarm signal is input during alarm
recording, the picture with the latest alarm signal
appears in the single screen display or split screen
display.
The screen returns to the previous display when the
alarm recording is completed.
The alarm display setting is available for either output
A or B. Select the desired output for alarm display.
You cannot use alarm display on both output A
and B at the same time.
(245 000 000) Press 4
System
Alarm Display Setting
Press 5
44
Multiplexer Settings