Operating Mode Setting; Online Module Change Setting; I/O Settings Outside Of The Group; Communication Area Setting (Refresh Setting) - Mitsubishi Electric MELSEC Q Series User Manual

6.1.2 Operating mode setting

This is set to continue operation of other CPUs where a stopping error has not occurred when an error occurs at other
than CPU No.1.íç1
The operating mode for the CPU No.1 cannot be changed (all CPUs will suspend operations when a stop error is
triggered for the CPU No.1.)
Section 3.10

6.1.3 Online module change setting

This setting allows modules to be replaced online when the Process CPU is used.
QCPU User's Manual (Hardware Design, Maintenance and Inspection)

6.1.4 I/O settings outside of the group

This is set when the input and output (X, Y) for I/O modules and intelligent function modules being controlled by other
CPUs is to be downloaded to the host CPU.
Section 3.4.2

6.1.5 Communication area setting (Refresh setting)

This is set up to automatically refresh the device data on the multiple CPU system.
Section 4.1.2
Basic
Note6.2
For the Basic model QCPU and the Universal model QCPU (Q00UCPU, Q01UCPU, Q02UCPU), the online
modulechange cannot be set.
For the High Performance model QCPU and the Universal model QCPU (except Q00UCPU, Q01UCPU, Q02UCPU),
modules cannot be replaced online. To replace modules online when using the Process CPU, set "Enable online
module change with another PLC.".
High
Universal
performance
CHAPTER6 PARAMETER ADDED FOR MULTIPLE CPU SYSTEM
1
2
3
4
5
6
7
8
6 - 8