Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Candy CDI 1012-2-80
Summary of Contents for Candy CDI 1012-2-80
- Page 1 CDI1012/2-80...
- Page 2 ....1 This manual contains sections of Safety Instructions,Operating Instructions, Installation Instructions and Troubleshooting Tips etc. Carefully reading it before using the dishwasher will help you to use and maintain the dishwasher properly.
- Page 3 Under certain conditions, Hydrogen gas may be produced in a hot-water system that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot-water system has not been used for such a period, before using the dishwasher turn on all hot-water faucets and let the water flow from each for several minutes.
- Page 4 To get the best performance from your dishwasher,read all operating instructions before using it for the first time. Pr ogramme indicator light:when you select washing program,the correspond light will display. Pr ogramme Key - press: To select washing p rogramme press the program key. ON/OFF Button : To turn on/off the power supply.
- Page 5 For the heaviest soiled loads, Pre-wash such as pots,pans,casserole Pre-wash (45 C) ° Strong 10/30 gr dishes and dishes that have Wash (70 C) ° been sitting with dried food Rinse (75 C) ° on them for a while. Drying Pre-wash For normally soiled loads, Wash (50 C)
- Page 6 If your model does not have water softener, you may skip this section. There are two ways to reduce the water hardness: one way is using water softener, the other is using detergent. The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils.
- Page 7 DO NOT ADD TO MUCH DETERGENT - THIS WILL PREVENT THE FORMATION OF DEPOSITS BECAUSE YOUR DISHWASHER HAS SPECIFICALLY DESIGNED WATER SOFTENERS. The dispenser must be refilled before the start of each wash cycle following the instructions provided i n the" Wash Cycle Table".Your dishwashers use less detergent and rinse aid than conventional dishwashers.
- Page 8 If there is no rinse aid warning light in the control panel, you can judge the amount of rinse aid by the following means. The black dot on the rinse aid dispenser indicates the amount of rinse aid in the dispenser. As the rinse aid diminishes, the size of the black dot decreases.
- Page 9 Cutlery should be placed in the cutlery basket with handles at the top: Knife Forks 1 1 1 1 1 1 1 1 1 Serving spoon Soup spoons 5 5 5 5 5 5 5 5 5 Gravy ladle Dessert spoons Serving fork Teaspoons 2 2 2...
- Page 10 The filter system consists of a filter cylinder(Coarse filter), A flat (Main filter) and a microfilter(fine filter). Main filter Food and dirt particles trapped by thi s filter are pulverized by a special jet on the lower spray arm and washed down the drain. Coarse filter Larger items, such as pieces of bone or glass, that could clog the drain are trapped in the coarse filter.
- Page 11 step 3： lift the Fine filter up NOTE： To remove the filter follows steps 1-3, to insert the filter reverse the procedure. To clean the edge around the door, you should use only a soft warm, damp cloth. To prevent penetration of water into the door lock and electrical components, do not use a spray cleaner of any kind.
- Page 12 Fused electrical supply is required-copper wire only. Time delay fuse or c ircuit breaker recommended and provide separate circuit serving only this appliance. Outlet should be placed in adjacent cabinet. Make sure that the plug on the appliance remains accessible after installation. After making sure that the voltage and the frequency values for the current in the home correspond to those on the rating plate and that the electrical system is sized for the maximum voltage on the rating plate, insert the plug into an electrical socket which is...
- Page 13 Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place. If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear and free of impurities.
- Page 14 Fuse blown, or the Replace fuse or reset circuit breaker. Remove any other circuit breaker acted appliances sharing the same circuit with the dishwasher Power supply is not Make sure the dishwasher is turned on and the door is turned on closed securely.
- Page 15 Combination of soft Use less detergent if you have soft water and select a water and too much shorter cycle to wash the glassware. detergent Tea or coffee stains Use a solution of 1/2 cup of bleach and 3 cups warm water to remove the stains by hand.
Need help?
Do you have a question about the CDI 1012-2-80 and is the answer not in the manual?
Questions and answers
Lower door seal part number required