Safety Precaution - Mitsubishi Electric BR-LM1KK Quick Start Manual

1 S a f e t y p r e
1 S a f e t y p r e
 This product requires special installation to prevent falling
or toppling. This should be done by installation specialists.
 Be sure to read this manual and the user's manual of the
display for your safety before starting assembly or
installation.
 Be sure to use supplied accessories for assembly or
installation.
 Attach all the screws and fixtures specified in this manual
securely.
 Do not dissolve or revamp the product except the areas
which are specified in this manual.
 Inspect the mounting fixings more than once in a year as
needed.
 Do not install the display with its intakes, exhaust slots and
ventilation holes blocked. The display may overheat and
cause a fire or breakdown.
To mount on a wall

Before mou
The weights of the displays and wall mount bracket
LM55S1: 37kg、LM55P1: 37kg、LM46P1: 24kg
BR-LM1KK: 12kg
 Carefully install onto the wall not to get loose due to
vibration etc. Wrong installation or installation with
insufficient strength causes the product to fall resulting in
a serious accident or injury.
 The weights shall be borne by a sturdy structural material
such as a joist. Secure the bracket using bolts, spring
washers, washers, and nuts.
 Don't install the bracket directly on a wall having
insufficient strength, or don't install it using wooden
screws or anchor screws. Also don't install it on wooden
structural materials or blocks.
 Install the displays not to touch with adjacent panels. The
outer circumference of the panels is quite weak and hard
pressure or impact may cause damage.
 Before installation, calculate cable length for external
connection and prepare them. Inappropriate length may
make the wiring difficult.
 Do not put your hands in the back of panel while closing
the display. You may be injured to trap your finger in the
bracket or between the panels.
c a u t i o n
c a u t i o n
How to handle the display
 Do not touch the top surface or left-hand surface as
viewed from the front surface of the display. Doing so may
cause failure.
 When ca
surface of the panel.
 Be careful not to twist or bend the display.
 Be careful not to bump or apply pressure on the panel.
 When laying the display flat, be sure to place the panel on
a flat surface with a something soft like a blanket
underneath, and be careful not to scratch the surface of
the panel or allow the panel to be subjected to excessive
pressure. Also do not leave the panel face-down for a long
while.
 Protect the panel from static electricity.
To keep static buildup to a minimum, remove the
protective sheet on the panel surface slowly.
 The surface of the panel is rather fragile and can be
damaged easily. Do not push down hard on it or scratch it.
 Immediately wipe away any drops of water or oil that
adhere to the panel. Allowing water or oil to remain on the
panel for long periods of time may result in the panel
becoming stained or changing color.
Vertical tiling
 In high configurations, the temperature condition gets
worse in the upper panels. The recommended stack
number in landscape orientation is up to 6, in portrait
orientation is up to 2. When over that configuration, it
requires an additional ventilation way to enhance the
efficiency.
usly support the bottom
EN-3