Summary of Contents for Mitsubishi Electric BR-LM1KK
Page 1
WALL MOUNT BRACKET MODEL BR-LM1KK for LM55S1, LM55P1, LM46P1 Quick Start Guide FOR INSTALLER Be sure to follow the directions below. This product requires special installation to prevent Warning: falling or toppling. Please ask installation specialists for installation. Don’t attempt to install this product by yourself.
Before mou The weights of the displays and wall mount bracket LM55S1: 37kg、LM55P1: 37kg、LM46P1: 24kg BR-LM1KK: 12kg Carefully install onto the wall not to get loose due to vibration etc. Wrong installation or installation with insufficient strength causes the product to fall resulting in a serious accident or injury.
Hole locations on the wall 1 Create following mount holes on the wall. (unit: mm) Create the holes fixing the cable ties to clamp the cables Tools suitably. Prepare the following tools.. Landscape Necessary tools [LM55S1/P1] Hex keys (4mm, 5mm) 2-M6 for Hook Phillips screwdriver (#2) 4-M6 for Base bracket...
Page 5
2 Remove in order ①2 display brackets (L/R), ②2 handles Portrait (L/R), ③4 lock bolts. [LM55S1/P1] Bolt, washer 2-M6 for Hook Base bracket 4-M6 Lock bolt For Base bracket (4pcs) Handle (L) Display Handle (R) bracket (R) Display bracket (L) 3 Place the panel on a flat surface with a something soft like a mattress or blanket underneath.
Page 6
8 Hang the base bracket at the center of bottom row (1) on the hook. Hook {LM46P1} Need the metal fitting specialy. Contact your MITSUBISHI dealer. 5 Attach the removed handle (L) (without wire) on the right lower corner of the panel seeing back side with the screws that fixed it on the wall mount bracket.
Page 7
10 Fix the bracket on the wall with supplied 4 bolts and 14 In the same manner, attach the brackets on the both washers. sides of it, (5) and (6). 15 Repeat the procedure to attach all brackets. Make sure that the vertical and horizontal distance between all brackets is proper (refer to page 4 ”Hole location on the wall”).
3.1 Display mounting Starting from the panel at the center of the middle row in 3 Hang the display brackets in the back of the panel on the the display wall, spread to its both sides and top / bottom. front bar so as to fit the hole and the protrusion toghether.
Page 9
6 Tie the wire with the clampers attached to the display not 7 Adjust the position of the handle(R) to turn the to .run it off the edge of the display. adjustment screw. Loosen the nut on adjustment screws Fix the wire on the back of the display not to pinch it. with wrench (8mm) before adjustment.
3.2 Display open / close Display closing Display opening Release the lock bar at the right lower side of the front bar to Pull up the handes on both sides to draw the panel til lift and push it. Release the display to pull up the handle(R) on the right sideof Push the panel lightly to slide till locked at the end.
Check in according with the following checklist after installing. Be sure to take measures if there is any fault. (Performance is not only be exhibited, but safety can not be ensured.) Item Measures in case of a fault Check □ - Is the strength of the wall enough? Reinforce the wall.