Led Status/Power Switch Board; Top Cover - NEC SX Service And Reference Manual

LED Status/Power Switch Board

The LED status/power board consists of a board that contains three connectors
and status LEDs. The connectors are for the VersaGlide, main board and
keyboard.
1. Remove one screw and lift the LED board starting at the left and working
right to disconnect the LED board from the main board.
2. Slide the LED board to the left to remove.
A – Connector P40 (underside)

Top Cover

The following describes the steps to remove the top cover.
1. Turn the system over so the bottom is facing up.
2. Remove a total of 14 screws:
T
9 from the bottom surface (
T
3 from the Versa Bay III Bay (
T
2 underneath keyboard, if not already removed
3. Turn the notebook over, remove two screws, and start at the right and work
left separating the top cover from the bottom assembly.
3-8 Disassembly and Reassembly
LED Status/Power Switch Board
B – Connector P42
)
A
B
C – Connector P41
)