NEC SX Service And Reference Manual page 43

T
Modem Ring Resume — Lets you choose whether the system resumes
automatically when an external modem receives a ring signal.
T
Wake Up from Suspend Alarm/Resume Alarm Time — Lets you set a
resume time from Suspend mode.
Boot Device Setup
Boot Device Setup allows you to define the following functions.
T
Quick Boot — Specifies whether or not the system performs all tests
during system boot.
T
Docking Station Video — Selects whether or not the Docking Station
video card is enabled at system boot.
T
Bootup NumLock — Specifies whether NumLock is On or Off at system
startup.
T
Boot Devices — Specifies the sequence of boot devices and whether or
not the system attempts to boot from a device other than those specified.
T
Other Boot Devices — Allows you to specify IDE devices as bootable
devices.
Peripherals Setup
The Peripherals Setup menu displays the connection locations between the
system and the Input/Output (I/O) ports. This menu also lets you specify
different port assignments as needed.
Note:
cannot enable or assign it using the Windows 95 device
manager. The device will not be listed in the Windows 95
device list. To control the device using the Windows 95
device manager, select any setting other than "Disable" in
Peripheral Setup.
This note does not apply to USB devices.
T
Internal Hard Drive — Allows you to enable or disable the Internal Hard
Drive.
T
USB Controller — Allows you to enable or disable the USB controller.
T
Serial Port — Allows you to disable the port or change its address
assignment.
T
Parallel Port/Parallel Mode — Lets you disable or reassign the parallel
port and select a parallel port mode.
T
IR Serial Port — Allows you to disable or reassign the IR Serial port.
If you disable a device in Peripheral Setup, you
System Configuration and Setup 2-21