LED Status/Power Switch Board
The LED status/power board consists of a board that contains three connectors
and status LEDs. The connectors are for the LCD panel switch, main board and
microphone.
1. Remove one screw and lift the LED board staring at the left and working
right to disconnect the LED board from the Main board.
2. Slide the LED board to the left to remove.
– Connector P40 (underside) B – Connector P42 C – Connector P41
A
Top Cover
The following describes the steps to remove the Top Cover.
1. The system needs to be bottom facing up.
2. Remove a total of 12 screws:
9 from the bottom surface (
3 from the Versa Bay III Bay (
3. Turn the notebook over and remove the top cover, start at the right and work
left separating the top cover from the bottom assembly.
3-8 Disassembly and Reassembly
LED Status/Power Switch Board
A
)
B
)