Table of Contents
Advertisement
HOW TO SET THE FACTORY PRESETS
Press and hold down CLEAR on the AVC System while it is in standby mode. Then press B on the Plasma
Display TV (Panel Unit) or the remote control unit to turn the Plasma Display TV on.
All setting items (except TV channel) return to the factory presetting.
A
• Running the factory presetting operation also clears the password.
You can run the Auto Installation again by using the following steps.
1
Turn on the power of the Plasma Display TV (Panel Unit) and the AVC System.
2
Press MENU. (Make sure the menu screen displays.)
3
Press b to select "Setup".
4
Press ENTER.
A
• If the password setting screen displays, you need to enter your password.
• If you forget your password, refer to HOW TO SET THE FACTORY PRESETS above.
5
Press a/b to select "Auto Installation".
6
Press ENTER.
"Auto Installation completed" displays. After that, the screen changes to the TV mode.
The password is
A
• As a precautionary measure, make a note of your password above, scissor it from this manual, and keep it in a familiar
place.
70
.
Advertisement
Table of Contents
