Bus Page; Monitor The Output Levels Of Buses 1-8/Aux Buses 1-8 - Yamaha AW4416 Operation Manual

Monitor the output levels of buses 1–8/AUX buses 1–8
[Function]
Monitor the output level of buses 1–8 and
AUX buses 1–8. In this page you can also
adjust the master level of each bus.
[Key operation]
• [HOME] key [F3] (Bus) key
• Repeatedly press the [HOME] key until
the screen shown at the right appears
[Mouse operation]
M button HOME button
[Screen functions]
A
Level meters
These meters show the output levels of buses 1–
8/AUX buses 1–8.
B
Faders
These faders adjust the master level of buses 1–
8/AUX buses 1–8. The fader location of each
bus is shown in dB units below each fader.
Tip!
To adjust the value of a fader, move the cur-
sor to the desired fader and rotate the [DATA/
JOG] dial.
C
STEREO OUT LEVEL
The location of the STEREO fader is shown in
dB units.
D
PRE FADER (pre-EQ) button
E
POST FADER (post-EQ) button
Select one of these two buttons to select the
location in the signal path (pre-fader/post-fader)
whose level will be shown by the level meters.

Bus page

2
Bus tab
1
3 4
Additional functions in the Bus
page
In the Bus page you can press the [SHIFT] key to
assign the following function to the [F1] key.
F1
• [F1] (PEAK HOLD) key
This key sets/defeats the Peak Hold function.
This is the same function as the [PEAK HOLD]
key in the level meter/counter section.
HOME screen
5
77
— Reference Guide