Miscellaneous Setup (Misc) Page; Word Clock Setup (Wclk) Page - Yamaha DME64N Owner's Manual

Miscellaneous Setup (Misc) Page

This page includes parameters not available in any other
page.
NOT E
The Remote setting (2) will not appear on the ICP1 control
panel display.
1
2
1 Scene Store
Determines whether or not scene store operations are
allowed. This parameter can be set to "Enable" or
"Disable."
Enable: Scene store operations are allowed.
Disable: Scene store operations are prohibited.
Edit using the "List Parameters" editing procedure
described on page 41.
NOT E
See page 43 for scene store procedure.
NOT E
This setting applies to individual devices only. Even if one
DME64N/24N unit is set to "Disable," scene store operations
will be possible via another DME64N/24N in the same zone that
is set to "Enable."
2 Remote
Determines the [REMOTE] connector communication
mode. Available settings are "HA Control (RS422)" and
"COM (RS232C)."
Edit using the "List Parameters" editing procedure
described on page 41.
This parameter must be set to "HA Control (RS422)"
when connecting to an AD8HR or AD824 remote head
amplifier.
Do not change the "HA Control (RS422)" setting while
connected a head amplifier to prevent possible damage to
the device(s).
When controlling the DME64N/24N from an RS232C
type controller set this parameter to "COM (RS232C)."

Word Clock Setup (WCLK) Page

Shows the status of incoming word clock signals, and
allows setup of the DME64N/24N master word clock.
N OTE
This page will not be displayed on the ICP1.
1
2
3
4
Master Clock Selection Procedure
1.
E ], [
Use the cursor [
to select one of the square blocks representing
the available master clock sources.
2.
Press the [ENTER] button to select the master
clock.
1 Fs
The current sampling frequency of the master word clock.
The value shown here is determined by the system's master
word clock signal. To select the word clock to be used as
the master, move the cursor to the appropriate word clock
indication in this display – the [WORD CLOCK IN]
clock, the cascade clock, or a slot clock, for example – and
press the [ENTER] button.
2 Int
Sets the frequency of the internal word clock – 44.1 kHz,
48 kHz, 88.2 kHz, or 96 kHz.
3 WCIN
Shows the status of the word clock signal at the [WORD
CLOCK IN] connector.
4 Cascade
Shows the status of the word clock signal at the
[CASCADE IN] and [CASCADE OUT] connectors.
5 SLOT1~4
Shows the status of the word clock signal input via I/O
cards installed in the I/O slots.
DME64N/24N Owner's Manual
Utility Displays
5
F ] buttons
], [ ], [
51