Rear View - Mitsubishi Electric DX-TL5000E Installer Manual

Rear view

1. MAIN switch
This is the main power switch. To use this unit, set
this switch to ON. Otherwise, the front power but-
ton will not turn the unit on/off.
2. AC power socket
Used to connect the power cord. Earth terminal is
used for safety. Use the 100 to 240 V plug with
ground terminal.
• This unit must be earthed at all times. Never
connect this unit to a power outlet which does not
have an earth terminal.
• Please use the supplied AC power cord.
3. CAMERA connectors
• Do not connect superimposed voltage camera
because it can cause damage to the unit.
CAMERA IN connectors
Input connector for signal of camera (BNC connector).
CAMERA OUT connectors
Outputs video signal from input camera. If the MAIN
switch is turned on, the signal from CAMERA IN
connector is looped out to this connector.
4. VIDEO OUTPUT connectors
OUTPUT A VIDEO connector
Output connector which sends video signal to dis-
play monitor (BNC connector).
OUTPUT A S(Y/C) connector
Output connector which sends brightness signals
and colour signals separately for higher picture
quality. Simultaneous output along with OUTPUT A
VIDEO connector is also possible.
OUTPUT B VIDEO connector
Output connector which sends video signal to sec-
ond (B) monitor (BNC connector) (
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Beginning
IN
1 2
OUT
IN
9 10
OUT
CLAMPER
~
AC IN
MAIN
100-240V
OFF ON
1 2
see page 17).
3 4
VIDEO VIDEO
3 4 5 6 7 8
Y/C
CAMERA OUTPUT A OUTPUT B
OUT IN
11 12 13 14 15 16
VIDEO CASCADE
SERIAL BUS
RESET
ALARM OUT ALARM IN
GND
RS-232C
11 12 13 14
5. VIDEO CASCADE connectors
VIDEO CASCADE IN connector
Input video connector for cascade connection.
VIDEO CASCADE OUT connector
Output video connector for cascade connection.
6. SERIAL BUS port
Input and output port for the device equipped with
SERIAL BUS connector. Do not use the power
control function of the external device which uses
bus power of this unit. Bus power cannot be used.
7. LAN-A port
Port for connection of NAS hard disk unit to back up
the recorded data.
LAN-B port
Port for communication using web browser.
8. AUDIO BOARD SLOT
Used to attach an optional audio interface board.
9. Keyhole for antitheft lock
Used to connect a commercially available antitheft
cable manufactured by Kensington.
10. OPTION SLOT
Used to attach an optional boards.
11. GND terminals
Used as common GND terminal.
12. RS-232C connector
Used to connect to a host device equipped with RS-
232C connector (such as a personal computer). This
unit can be controlled from other devices via this
connector.
8 9 10
5 6 7
AUDIO IN
1 2
OPTION SLOT
3 4
OUT IN
CLAMPER
AUDIO CASCADE
AUDIO OUT
SERIAL BUS
LAN-A LAN-B
100 10 100 10
STORAGE COM
P T Z
RS485 RS485
OUT IN
15 16 17
15