Bright Compensation [Brt Command]; Color Compensation [Col Command] - Pioneer RM-V1000NU Technical Manual

APPENDIX (MVP manual)

Bright Compensation [BRT command]

Input: BRTd
Explanation: Corrects the brightness of the NTSC input board.
d
BRTd
• To execute this command, it is necessary to set the adjustment mode by AJYB. (Refer to the
AJYB command.)
• The changed value will be memorized the last.
(Example) BRT3
* Sub command mode of BRT command

Color Compensation [COL command]

Input: COLd d d
1 2
Explanation: Corrects the color of the NTSC input board.
d d d
1 2 3
COL?
COL
• To execute this command, it is necessary to set the adjustment mode by AJYB. (Refer to the
AJYB command.)
• If data input is skipped, the sub command input mode is set after the data is displayed.
COL sub command mode
The COL sub command mode is set by COL
(Example) COL
*** indicates the current value.
Input the following sub command at the
Always input
• The changed value will be memorized the last.
(Example) COL
118
: Compensation value 0 to F
: Displays the current value and moves to the sub command mode
Sets the bright level to 3.
The sub command mode is set by BRT
(Example) BRT3
*
* indicates the current value.
Input + and – at the
Always input (CR) to end.
3
: Compensation value 0 to 255
: Help display
: Displays the current value and moves to the sub command mode
***
(CR) to end.
0 to 255 : Ends the sub command mode after a number has been input.
+, – : Increases/decreases the data by one step.
UP1 to 9, 0 : Increases the current data by 1 to 10 steps.
DW1 to 9, 0 : Decreases the current data by 1 to 10 steps.
RES : Defaults the adjustment value (factory setting).
: Ends the sub command input mode.
UP0 : Increases the color compensation value by 10 steps.
.
cursor position.
.
cursor position.
*