Connection With Mvp External Computer - Pioneer RM-V1000NU Technical Manual

CONNECTION WITH MVP EXTERNAL COMPUTER

• Refer to Chapter 4.(P.69) "External Control by MPJ RS-232C" for how to adjust the MPJ.
¶ Use a RS-232C straight cable.
¶ Refer to the following diagram for connections.
¶ MVP RS-232C Settings
<MVP RS-232C Pin Layout>
1
14
13
25
Connection with External Computer
<External Computer Side>
Straight
FG 1
TxD 2
RxD 3
RTS 4
CTS 5
DSR 6
SG 7
Baud rate : 2400, 4800 , 9600, 19200
Bit number : 7, 8
Parity : NON , ODD, EVEN
Stop bit : 1 , 2
: Setting at shipment
This setting can be changed using the DIP switches on the panel.
Refer to "Chapter 2.(P.14) MVP panel 8 Baud rate switch".
Signal name
<Video Processor Side>
RS-232C IN
1 FG
2 Rxl
3 Txl
4 CTSl
5 RTSl
6 DSRl
7 SG
FG Frame Ground
Tx (D, I, O) Trandmitted Data
Rx (D, I, O) Received Data
RTS (I, O) Requenst to Send
CTS (I, O) Clear to Send
DSR (I, O) Data Set Ready
SG Signal Ground
*
* Pins 5 and 6 are short-circuited inside.
Pins not shown in the diagram are NC.
APPENDIX (MVP manual)
105