Installation Check - Dell Broadcom NetXtreme Family of Adapters User Manual

VMware Driver Software: Broadcom NetXtreme II Network Adapter User Guide
Physical NIC: vmnic7
User Priority: 3
VLAN id: 2008
The output of this command should show valid:
FCF MAC, VNPort MAC, Priority, and VLAN id for the Fabric that is connected to the C-NIC.
The following command can also be used to verify that the interface is working properly:
#esxcfg-scsidevs -a
Output example:
vmhba34 bnx2fc link-up
vmhba35 bnx2fc link-up
NOTE: The label "Software FCoE" is a VMware term used to describe initiators that depend on the inbox FCoE libraries and
utilities. Broadcom's FCoE solution is a fully state connection-based hardware offload solution designed to significantly reduce
the CPU burden encumbered by a non-offload software initiator.

Installation Check

To verify the correct installation of the driver and to ensure that the host port is seen by the switch, follow the procedure
below.
To verify the correct installation of the driver
1. Verify the host port shows up in the switch FLOGI database using the "show flogi database" command for the case of a
Cisco FCF and "fcoe -loginshow" command for the case of a Brocade FCF.
2. If the Host WWPN does not appear in the FLOGI database, then provide driver log messages for review.
Limitations
FCoE Boot from SAN is not currently supported
NPIV is not currently supported with this release on ESX, due to lack of supporting inbox components.
Non-offload FCoE is not supported with offload-capable Broadcom devices. Only the full hardware offload path is
supported.
Please read all Restrictions and
Back to Contents Page
file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/vmware.htm[9/26/2012 3:28:54 PM]
fcoe.1000<mac address>:2000<mac address>
fcoe.1000<mac address>:2000<mac address>
Disclaimers.
() Software FCoE
() Software FCoE