Dell Broadcom NetXtreme Family of Adapters User Manual page 122

Broadcom Teaming Services: Broadcom NetXtreme II Network Adapter User Guide
11 Informational
12 Error
13 Informational
14 Informational
15 Informational
16 Warning
17 Informational
18 Informational
19 Informational
20 Informational
Virtual Bus Driver (VBD)
Table 10: Virtual Bus Driver (VBD) Event Log Messages
Message
Severity
Number
1 Error
2 Informational
3 Informational The network link is up.
4 Informational
file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/teamsvcs.htm[9/26/2012 3:29:14 PM]
Network adapter is
connected.
Broadcom Advanced
Program Features Driver is
not designed to run on this
version of Operating
System.
Hot-standby adapter is
selected as the primary
adapter for a team without
a load balancing adapter.
Network adapter does not
support Advanced Failover.
Network adapter is
enabled via management
interface.
Network adapter is
disabled via management
interface.
Network adapter is
activated and is
participating in network
traffic.
Network adapter is de-
activated and is no longer
participating in network
traffic.
The LiveLink feature in
BASP connected the link
for the network adapter.
The LiveLink feature in
BASP disconnected the link
for the network adapter.
Message
Failed to allocate
memory for the device
block. Check system
memory resource
usage.
The network link is
down. Check to make
sure the network cable
is properly connected.
Network controller
configured for 10Mb
half-duplex link.
Network controller
The physical adapter is
connected to the network (it
has established link).
The driver does not support
the operating system on
which it is installed.
A standby adapter has been
activated.
The physical adapter does
not support the Broadcom
NIC Extension (NICE).
The driver has successfully
enabled a physical adapter
through the management
interface.
The driver has successfully
disabled a physical adapter
through the management
interface.
A physical adapter has been
added to or activated in a
team.
The driver does not
recognize the installed
adapter.
The connection with the
remote target(s) for the
LiveLink-enabled team
member has been
established or restored
The LiveLink-enabled team
member is unable to connect
with the remote target(s).
Cause
The driver cannot
allocate memory from
the operating system.
The adapter has lost its
connection with its link
partner.
The adapter has
established a link.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
The adapter has been
No action is required.
Consult the driver release notes and
install the driver on a supported
operating system or update the driver.
Replace the failed physical adapter.
Replace the adapter with one that does
support NICE.
No action is required.
No action is required.
No action is required.
No action is required.
No action is required.
No action is required.
Corrective Action
Close running applications to free memory.
Check that the network cable is connected,
verify that the network cable is the right type,
and verify that the link partner (for example,
switch or hub) is working correctly.
No action is required.
No action is required.