Table Of Contents; Product Specifications - Craftsman 183.172500 Owner's Manual

SECTION PAGE
warranty ........................................ 2
Product Specifications ....................... 2
Power Tool Safety ............................ 3
Cutter Safety .................................. 4
Elech'ical R equirements & Safety ........ 5
Accessories
....................................
5
SECTION PAGE
Carton Contents .............................. 6, 7
Know Your Cutl_. ............................. 8
Assembly & OpemUon ...................... 9 - 17
Maintenance ................................... 17
Repair Parts ................................... 18 - 22
Parts & Service Availability ................ 23
llllJ
FULL ONE YEAR WARRANW
If this Cutter fails due to a defect in material or workmanship within one year of date of
purchase, Sears will at its optionrepair or replace it free of charge.
Returnthis Cutter to a Sears Service Center for repair,or to place of purchase for replacement.
This warranty gives you specific legal fights, and you may also have other rights which may vary
from state to state.
Seam,
Roebuck and
Co., Dept. 817 WA, Hoffman Estates,
IL 60179
l&
WARNING I
Some dust created by power sanding, sawing, grinding, drilling and other coaMructlon activities contains
chemlcaia known (to the State of California) to cause cancer, birth defects or olther reproductive harm. Some
exampfes of these chemicals are:
• Lead from iaad-based paints
• Crystalline silica Wont bricks, cement and other masonry products
• Arsenic and chrominm from chem..ally treated lumber
Your risk from these exposure varies, depending on how often you do this type of work. To reduce your
expo6ure to these chemicals, work In a well ventliated area and wod( _ approvad safety equipment such as
those dust masks that ere specially designed to filter out microscopic parl_.
l;,l [o] lU[oM
Motor Rating ...................... 120V, 60Hz, AC Motor Horsepower ...... tl3 HP (Ma_mum Developed)
Amperes ........................... 4.0 Amperes Weight ..................... 3.75 kg
Speed (no load) .................. 30000 RPM
I,_, WARNINGI
To avoid electrical hazards, fire hazards or damage to the cutter, use proper circuit protection.
This cutter is wired atthe factory for110-120 Volt operation. It must be connecl_d to a 110-120 Voit115 Ampere
time delay fuse or curcuit breaker. To avoid shock or fire, replace power cord immediately If It is worn, cut or
damaged in any way.
Before using your cutter, It is crltinal that you read and undemtand these mlGety rules. Failure to follow these
miss could result in serious injury to you or damage to the cutter.