Table Of Contents; Warranty; Product Specifications - Craftsman 183.17253 Owner's Manual

SECTION PAGE
Warranty ........................................ 2
Product Specifications ...................... 2
Power Tool Safety ............................ 3
Cuffing Too_Safety ........................... 4
Electrical Requirements & Safety ........ 5
Accessories .................................... 6
SECTION PAGE
Carton Contents .............................. 6, 7
Know Your Cuffing Too/ .................... 8
Assembty & Operation ...................... 9 - 13
Maintenance ................................... 13
Repair Parts ................................... 14 - 17
Parts & Service Availability ................ 18
FULL ONE YEAR WARRANTY
If this Cuffing Tool fails due to a defect in material or workmanship within one year of date of
purchase, Sears will at its optionrepair or replace it free of charge.
Return this Cuffing Tool to a Sears Service Center for repair, or to place of purchase for
replacement.
This warran0/gives you specificlegal rights, and you may also have other rights which may vary
from state to state.
Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, IL 60179
[A WARNING I
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
Lead from lead-b;_ed paints
Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures verles_ depending on how often you do this type of work. To reduce your exposur_
to these chemicals, work In a wall ventilated area and work with approved safety equipment such as those dust
masks that are specially designed to filter out microscopic p;lrticles.
Motor Rating ...................... 120V, 60Hz, AC
Amperes ........................... 5.0 Amperes
2 Speeds (no load) .............. 20000 & 30000 RPM
Motor Horsepower ...... 3/4 HP (Maximum Developed)
Weight ..................... 1.7 kg
]Jh_ WARNING]
To avoid electrical hazards, fire hazards or damage to the cutting tool, use proper circuit protection.
This cutting tool is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt 115
Ampere time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut
or damaged in any way.
Before using your cutting tool, it is critical that you read and understand these safety rules. Failure to follow these
rules could result In serious InJery to you or damage to the cutting tool.