Advertisement
SPECIFICATIONS
Collet ...................................................... 1/4 In. Hsx shank
Motor ................................................................ 3.6 Volt DC
Switch ....................................... Single Speed / Reverside
Gear Train ............................................................. 1 Speed
No Load Speed .................................................... 180/mln.
KNOW YOUR SCREWDRIVER
See Figure 1.
Before attemptingto use your screwdriver,familiarize
yourselfwith all operating features and safety
requirements,
,_, WARNING: Do not attem_ to use this producturXll
you read thoroughly and understandcompletelythe
operator'smanual. Pay close atl:entlonto the safety
rules, Including Dangers, Warnings,and Cautions. ff
you use this productproperlyand only as ]mended,
you will enjoy years of safe, reliableservice.
WARNING: Do not allow farnflladtywith your
screwdriverto make you samless. Remember that a
careless fractionof a second Is sufficient to Inflict
severe Injury.
Clutch ............................................................. 22 Positions
Charger Input ................................. 120 V, 60 Hz, AC only
Charge Rate ................................................... 10-1 2 Hours
Torque ..................................................................... 50 InJb
SWITCH
Your screwdriveris equippedwth a rockertype switch
whichturnsyour screwdriverON and OFF. This switch
alsocontrolsthe forward and reverse feature. For driving
screws,depress right side of switch.For removingscrews,
depress left side of switch.
STICK/PISTOL
COMBINATION
SCREWDRIVER
Your screwdriver has been designed so that it can be
operated as a stick screwdriveror a pistolscrewdriver.
LIGHT
Your screwdriverhas a bulit In light. This feature is
convenientwhen workingIn close or tight areas where
additional
light Is needed.
TORQUE
ADJ USTMENT CAP
VIEWOF SCREWDRIVER IN STICKPOSITION
O
SWITCH
(ON/OFR
(FQRWAFJ_/RBVERSE)
UGHT
7
Advertisement
