Advertisement
TO CHARGE SCREWDRIVER
USING CHARGING
STAND
See Figure 4.
•
Place screwdriverIn charging stand malting sure
InputJackand charger plug are propedyconnected.
•
Align slotson screwdriverwith tabs on charging stand
then push on screwdriverto snap into place.
•
Connect charger to power supply.
•
A_er normal usage, a minimum of 10 hoursof charg-
Ing time Is required to fully charge screwdriver.
•
Do not place charger In an area of extreme heat or
cold. It will work best at normal roomtemperature.
SLOTS
CHARGER
COLLET
The coUetonyour screwdriverhas been designedto accept
1/4 In. hex bits.See Figure 6.
TO INSERT BIT
See Figure 6,
Insert bit Into collet as far as ppsslbTB.
BIT
COL_
Fig, 6
LIGHT
See Figure7.
Your screwdriverhas a built In light. This feature Is
convenientwhen worldng In dose or tight areas where
additionallight Is needed. A slide switchis Iocatad on the
bottomof your sorewddver,To turn lightON, push switch
forward,To turn lightOFF, peUback on switch.
Note: Always tum light off on our screwdriverwhen not In
use,
CHARGING
STAND
Fig. 4
STICK/PISTOL
COMBINATION SCREWDRIVER
See Figure 5,
Your screwdriverhas been designed sothat Itcan be
used as a stickscrewdriveror a pistolscrewdriver.As
shown In Figure 5, a rotationbutton is located on the side
of your screwdriver.To pl,_ceyour screwdriverIn pistol
position,hold It In normal operating position,depress
rotationbuttonand pushdown on handle. To place your
screwdriverIn stick position,held it In normal opermlng
position,depress rotationbuttonand pull up on handle.
ROTATION
BuTroN
Fig
\
.5
UGHT
LIGHT
SWITCH
Fig. 7
10
Advertisement
