Assembly Of Extensions And Legs; Mounting Router To Table - Craftsman 25481 Instructions For Assembly And Operation Manual

ASSEMBLY OF EXTENSIONS AND LEGS
t. Toassemblethe EXTENSIONS and LEGSto ROUTER TABLE,
placetable, top side down, on a smooth, flat surfi_ce,and position
the LEGSand EXTENSIONS relativeto the TABLEas shown in
Figure1. htsert the #10-32 x Yi' screwthrough the LEGand install
lock washer and nut. This is to be done for eachtable leg.
2, Makesure all screws and nuts are securelytightened,
3. Turnthe tabletop side up and checkto see that tfm
EXTENSIONS are evenwith or slightly belowthe table top.
4, In no caseshould the EXTENSIONS be higher thanthe table, or
elsethey may interfere with the workpieceduring routing causing
a condition that can result in possibleserious injury.
5. If the extensionsare higher than the top of the table, loosenthe
screws holding the EXTENSIONS and reposition them so they art;
evenwith or slightly lower than the top of table, SECURELY
TIGHTEN ALL SCREWS AND NUTSAGAIN,
6. To double check, slide a flat pieceof wood along the top of the
tableboth directions, Make surethat the end of the wood moves
freely without contacting the edgeof the EXTENSION next to table,
DO NOTPLACE HEAVY OBJECTS OR PRESS
HEAVILY ONTHE EXTENSIONS ORELSE
THEYMAYBEDAMAGED CAUSING A CONDITION THATMAY
CANRESULT IN POSSIBLE SERIOUS 80DtLY INJURYDURING
ROUTING.
FIGURE 1
MOUNTINGROUTERTO TABLE
ALWAYSUNPLUGROUTER BEFORE MOUNTING (The tablewill acceptCraftsman3 hole 6 in. diameter base).
, i:f •
1. Removethe router baseplate(back plate)from the router. '
2. While holding the router upsidedown, position it to the
undersidewithin the center ring of the table top, as shown in
Fig.#2,
3. Rotatethe router until the three mounting holes in the router
baseline up with threeof the holes in the table top (It will be
helpfulif you orient the router such that you can easily reach the
ON/OFF switch from the front of the table. Craftsman_- 2 5183
Router TableSwitch Packageprovideseasy access to ON/OFF
button).
4. Insert three #!0-32 x _" long flat head machine screws
(provided) through holes in the tabletop (See Fig, #2) and tighten
securelyinto the router base.
FIGURE2
5