Selecting And Installing Table Inserts; Assembly Of Unitized Fence; Assembling Of Jointing Fence To Unitized Fence - Craftsman 25481 Instructions For Assembly And Operation Manual

SELECTING AND INSTALLING[ABLEINSERTS
1.With the desiredbit in the router, selecta table insert which has a
center hole slightly larger thanthe diameter of the router [)it. Note:
Forbits larger than approximately!_;" diameter,do not usean
insert,
2, Thetable insertsare designedto be snappedinto the router table.
Stidethe large tang under the edgeof the large hole in the router
tableas shown in Fig. #3. Using your thumb, press down on the
insert until the small tang snaps into position
3, Toremove the insert, placethe blade of a small screwdriver into
the slot (with the small tang) and pry the insert out of [he router
table.
BEFORE ASSEMBLING ANDATTACHING
UNITIZEDFENCE TOTABLE,MAKESURE
THATROUTER IS UNPLUGGED ANDTHEBIT IS BELOW THETOP
SURFACE OFTHETABLE.
HGURE 3
ASSEMBLY OFUNITIZED FENCE
1, Slidejointing fencethrough rectangularopening in the cavity
providedon the unitizedfence(ribs on the unitizedfence will slide
in the grooves on the undersideof jointing fence). SeeFig. #4a &
#4b.
2, Insert ;./.-20 x t" tong hex head bolt through the hole in the
unitizedfence (from the underside)and the slot in the jointing
fence,
3. While holding the headof the bolt in the hex recesson the
undersideof unitized [ence,placea flat washer over the bolt and
screwsmall _-20 knob on bolt.
Whenknob is loosened,the jointing fence canslide back and forth
in the cavity for proper iointing adjustment.
FIGURe." 4a
FIGURE4b
6