Routing Using Backside Of Unitized Fence - Craftsman 25481 Instructions For Assembly And Operation Manual

NOTE: W hen cutting tenons,alwaysclamp work[)ic(:_,_,_.Ati, (:nd to
be cut resting on edgeof tabletop hote,1his will inmnuize ste_s m
finished tenor] surface (Fig.#25) due to w.triationsin lhe tabletop
flatness,
ALWAYS CUTFULLDEPTHON ALL4 SIDES
OFTENONIN ONEPASSACROSS THE6IT,
ONCE THESIDESARECUTANDIF STEPSOROTHER
IMPERFECTIONS A RENOTICED ON FINISHED TENONSURFACE,
CLEAN THEMWITH WOO0CHISEL,SANDPAPER ORFILE, ETC.
DONOTTRYTO CLEAN THEMBY RE-SETTING WORKPIECE ON
ROUTER TABLE AND FENCE, W ORKPIECE MAYINTERFERE
WITH GUARD (SEEFIG. #21) WHICHiN TURNWILL PREVENT IT
FROMSLIDINGACROSS THEBIT.
STEPStN FINISHED
TENON SURFACE
FIGURE25
OPERATION ROUTING USINGBACKSIDE OF
UNITIZED FENCE
USEBACKSIDE OFFENCE ONLYFORROUTING OPERATIONS
AWAYFROMEDGEONTHE UNDERSIDE OFWORKPIECE, SUCH
AS GROOVING, FLUTING, V EINING,CROWNMOLDING,ETC,
ALWAYSUNPLUGTHEROUTER BEFORE MAKINGANY SETTING,
ADJUSTMENTS, ORCHANGING BITS.
WHENROUTING, A LWAYSFEED AGAINSTTHEROTATION OF
THECUTi'ER.FEED WORKPtECE IN THE DIRECTION OFARROW
AS SHOWNON LABELONTHE SIDEOFFENCE BEINGUSED
(when facing the table front),
DO NOTCONNECT WET/DRYVACWHENUSINGBACKSIDE OF
FENCE, T HEHOSEWILL HINDEROPERATION.
t. Removeboth large knobs and k._-20 x 1_" lg. hex head botts,
turn the unitizedfence around and attach it back to table with
backsideof fence facing the table front. See Fig. #26. (MAKE
SUREROUTER IS UNPLUGGED WHENREMOVING AND
ATTACHING FENCE TOTABLE).
2. Raiseguard and let it leanagainst,the fence.
3. Position the fence behind the router bit for the desiredcutting.
depth (the distanceof the cut from the edge of the workpiece,as
shown in Fig. #27).
FIGURE26
FIGURE27
14