Location And Function Of Controls - Craftsman 113.213170 Owner's Manual

location and function of controls
1. BELT TENSION HANDLE... Turn handle counter
c!ockwfse to apply tens,on to belt. turn handle
clockw,se to release belt tension.
2.
BELT TENSION LOCK HANDLES... Tightening
handles locks motor bracket support and BELT
TENSION HANDLE to maintain correct belt d_s-
tance and tens=on.
3. HEAD LOCKS... Lock the head to the column.
ALWAYS have them locked m place wh=leoperat-
ing the drill press
4. SUPPORT LOCK... Tightening locks table sup-
port to column. Always have it locked =nplace while
operating the DrHt Press.
5. TABLE CRANK . . . Turn clockwise to elevate
table. Support lock must be released before operat-
ing crank.
6. TABLE BEVEL LOCK... Locks the table in any
position from 0°.--45_.
7. TABLE LOCK ... Allows table to be rotated an
various positions and locked.
8. FEED HANDLE... For moving the chuck up or
down. One or two of the handles may be removed
=f necessary whenever the workpiece =s of such
unusual shape that it interferes with the handles.
10
TABLE REMOVED
FOR CLARITY
14.
15.
16.
9. CHUCK... Holds drdl b=tor other recommended
accesso_/to perform desired operations.
10. BEVEL SCALE... Shows degree table is tilted
for bevel operat=ons Scale _s mounted on side of
arm.
11. SPRING CAP... Provides means to adjust quill
sprmg tens=on.
12. DEPTH SCALE... Allows operator to adjust drill
press to drill to a desired depth.
13. DRILL "ON-OFF" SWITCH... Turns drill press
on and off .... also used to lock drill press in off
pos=t=on.
LIGHT "ON-OFF" SWITCH... Turns the light on
and off.
CHUCK KEY... Used to tighten drill in the chuck
and also to loosen the chuck for drill removal.
DEPTH SCALE LOCK... Locks the depth scale
at selected position.
16
14
13
€
..=