Mounting Motor; Installing Motor Pulley; Tensioning Belt - Craftsman 113.213170 Owner's Manual

1. Locate four (4) 8mm, t, DJa x 20ram long hex head _f,f . : . _S_//UOTO R---
bolts, eight (8)flat _vashers, and four (4) hex nuts /" _, z_.,,_'//
among,oose a.s. ...->./ s'
2. Install hex head bolts through motor bracket on
./ ._/ ._/____
HI_X
head. -_ .!._.y ..___-_o_.._'_...'_| NUT
3. Place motor in position so motor base slotsline up
--_"
_'] ___fJ /
with motor bracket slots. Install flat washers and __r t,.__ I",l,,"_-J}_-',_'_nnll_1
I
hex nuts as illustrated. (Do not tighten)
_I I_[_i_
Uuv" "--,_ _1_ -
4. Motorshaftshouldbeascloseaspossibletocenter :_J'/ '_
I I
of round opening in belt guard. _
J I
_ " _ FLAT .
Ilmm DIA. ,, 2DramLONGBOLT HEXNUT "_ FLATWASHER ,
I
MOTOR
PULLEY
INSTALLING MOTOR PULLEY
1. Find the motor pulley in loose parts bag.
2. Slide pulley onto motor shaft. Line up the flat sur-
face on the motor shaft with the set screw in pulley.
3. Make sure the pulley does not rest on the lower
guard.
4. Tighten the set screw using a "4" mm Hex"L"wrench.
FLAT
SURFACE
INSTALLING AND TENSIONING BELT
WARNING: TO AVOID INJURY DUE TO ACCIDEN-
TAL STARTING ALWAYS TURN DRILL PRESS OFF
AND REMOVE SWITCH KEY BEFORE MAKING
BELT ADJUSTMENTS.
1. Place a straight edge such as a piece of wood,
metal, or framing square across the top of pulleys.
2. Move the motor upward until the pulleys are in line.
Tighten the motor mount nuts using an adjustable
wrench.
NOTE: To avoid rattles or other noise, motor frame
must not touch lower belt guard.
3. Release Belt Tension Lock handles located on
each side of Drill Press head by turning them
counterclockwise.
STRAIGHT EDGE
BELT
LOWER TENSION MOTOR
BELT LOCK MOUNT
GUARD HANDLE NUTS MOTOR
BELT
TENSIOr_
HANDEE
4. Loosen Belt Tension handle by turning clockwise.