Table of Contents
Advertisement
RE-INSTALLING
THE CHUCK AND ARBOR
t. Clean thetapered surface on thearbor with a clean
cloth. Make surethere are no foreignparticlesstick-
ing to the surface. The slightest piece of dirt on
this surface will prevent the arbor from seating
properly.This will cause the drillto "wobble."
2. Slide arbor into spindle on drillpress.
3. Push up on chuck/arbor assembly as you rotate
them. You will feel rectangular end of arbor slip
_otoa notch in the spindle.
WARNING:
MAKE SURE THE RECTANGULAR
END
OF THE ARBOR
HAS SLIPPED
INTO THE NOTCH
IN THE SPINDLE BEFORE
GOING ON TO STEP 4.
FAILURE
TO
FOLLOW
THIS
DIRECTION
MAY
ALLOW
THE CHUCK
TO COME LOOSE
DURING
OPERATION,
FLY OUT, AND HIT THE OPERATOR.
SPINDLE
ARBOR
CHUCK
SLEEVE
CHUCK
eDDY
4. Unlock support lock and raise fable so its about
two (2) inchesbelow tip of chuck.
5. Turn chuck sleeve clockwise and open jaws in
* chuck'completely.
6. Turn feed handles counterclockwise and force
chuck against table until arbor is secure.
SUPPORT
LOCK
FEED
HANDLE
CHUCK
CHUCK
SLEEVE
22
Hide quick links:
Advertisement
Table of Contents
