Installation Of Cup And Spur Centers - Craftsman 113.228360 Owner's Manual

11.From theloosepartslocatea #6 x3/8phillips head
screw(see illustration). U singa
#2 phillips head
screwdriver install this motor cover stop screw, it is
located on backside of headstock as shown in illust-
ration.
WARNING: the motor cover stop screw is for your
protection, it prevents the motor cover from slid-
ing back too far when moving belt for speed
changes, it protects you from touching heated
motor after lathe use. it must be reinstalled.
MOTOR
COVER
MOTOR
COVER
STOP SCREW
#6 x 318 PAN HEAD SCREW
BED
#2 PHILLIPS
HEAD .-""
SCREWDRIVER
u i ii i .| i i,,m i i i i iiii i i iii
INSTALLATION OF CUP AND SPUR
CENTERS
1, Finda 3/4-16 hex nut among the loose parts and
screw it onto headstock spindle until finger tight,
SPINDLE
i i
3/4-16 HEX NUT
tD-O_
--I =..
O
_=
ill i
CENTER POINT
ill
CUP CENTER
/
D
2. Find two center points, a spur center, and a cup
center among the loose parts. To insert a point into
a center, hold the center agatnst workbench as
i_Lustrated. Check and be sure that inside of open-
ing at the end of center is clean. Place a point into
opening and using a small board, gently tap the
point into the center.
Repeat this process on the other point and center.
i i ii i i . illl i,iil,lll
i i •
;i i,!; R,CENTERi: i'! _ :i_Li_,:
CENTER POINT